Cyclic strains of joints may cause formation of a crack or cracks in a bolt thus changing its loading conditions. After crack appearance in a bolt it can be used if its length does not exceed a critical one. Modification of the shakedown theorem – the method of additional load – was applied in the investigation. The results – the analytical expressions of shakedown conditions are in a sufficiently good agreement with those achieved by other methods. Differences occur due to failure to get an accurate analytic expression. Solution of the shakedown problem plays an essential role in determining the safety factor of bolts subjected to cyclic strains.
Leonavičius, M., & Sušukšta, M. (2002). Shakedown of bolts with a one-sided propagating crack. Journal of Civil Engineering and Management, 8(2), 104-107. https://doi.org/10.3846/13923730.2002.10531260
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.